Drive device for belt feeder
Hello everyone, I am Wang Can from Dongda Electromechanical and welcome your reading and clicking
The drive device consists of: reducer and electric motor
The electromagnetic clutch of the drive device It has the function of realizing the start, stop and conversion of both functions of the feeder. The belt speed of the metering belt conveyor is less than /, and a speed detection device is provided to measure the belt speed. The hydraulic vibrating brick press has been basically eliminated due to the vibration pressurization method, low pressure and insufficient density of bricks, and will not be described in detail here. The hydrostatic hydraulic brick press is stable due to its pressurization.
The failure rate is low, and secondary exhaust can be set up, so the pressed finished product has the advantages of standard appearance and size and high density. A discharge tray assembly is provided below the bottom port of the cylinder, and a discharge channel is formed between the upper surface of the discharge tray assembly and the bottom port of the cylinder. Different lining types can be used according to production needs. When installing the barrel part of the ball mill, the entire pre-assembled simplified part can be installed directly based on specific conditions, or it can be installed in several parts. The journal and the center of the ball mill should be checked and adjusted.
Adjustment of discharge granularity: A wedge or gasket adjustment device is installed between the two rollers. The top of the wedge device is equipped with an adjustment bolt. When the adjustment bolt pulls up the wedge, the wedge will move the movable roller. Pushing away from the fixed wheel means that the gap between the two rollers becomes larger and the discharge granularity becomes larger. The impact crusher consists of seven parts: feed hopper, distributor, vortex crushing chamber, impeller body, main shaft assembly, base, transmission device and motor. The material falls vertically from the upper part of the machine into the high-speed rotating impeller. Under the action of high-speed centrifugal force, it collides with the other part of the material that is shunted around the impeller in the form of an umbrella and is crushed at high speed.
The layout of the driving device should meet the requirements of the belt conveyor layout diagram.
Company: Jining Dongda Mechanical and Electrical Co., Ltd.
Contact: Wang Can
Mobile:
Telephone:
Fax:
Drive device for belt feeder